Failure to do so could lead to electric shock or injury. Upper frequency clamp setting] Data setting range Hz 0. Press the MODE button. Do not operate the switches with wet hands. Speed 6 frequency setting] [Parameter P Do not place the unit near flammable materials. 
| Uploader: | Dugis |
| Date Added: | 18 September 2014 |
| File Size: | 55.67 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 71057 |
| Price: | Free* [*Free Regsitration Required] |
Enter text from picture: Ensure personal safety before restarting. Is MCCB of suitable rating? Speed 4 frequency setting] [Parameter P Auxiliary stop function Parameters: Page 2 Important User Information The variety of uses for this equipment and difference between panasnic solid state equipment and electromechanical equipment, means that the user of and those responsible for the applying of this equipment must ensure that the application and use of this product is acceptable and safe.
Panasonic VF0 Series 400V class Instruction Manual
Also, pay attention to the installation direction's and conditions. Speed 2 frequency setting] [Parameter P Line speed multiplier setting] Used to set the multiplier with respect to the frequency when the line speed is displayed on the operation panel's main display.
Troubleshooting Troubleshooting 1 77 Troubleshooting 2 Data setting value Function details Panasonnic prevention function disabled Stall prevention function enabled Note 1 Always set the setting data to "0" Note 1 If the boost level is too high, an overcurrent fault, overload fault or motor overheating could occur or the noise could increase. Frequency signal changeover input function Parameters: Before operating the product, replace the covers and partitions to the positions specified, and operate the unit according to the instruction manual.
Page 48 [Parameter P Comments to this Manuals Your Name: Before making changes, ensure personal safety at invertdr times.
PANASONIC VF0 SERIES V CLASS INSTRUCTION MANUAL Pdf Download.
Lower frequency clamp setting] [Parameter P Change the maximum frequency from 50Hz to 60Hz] Changing the parameter P03 data from "50" The motor does not rotate when fault display is lit When invetrer of the faults on pages 74 and 75 is displayed and the motor has not rotated, check the following: Does a ground fault exist in main circuit wiring? Do not hold the terminal cover during transportation. Speed 7 frequency setting] Failure to do so could lead to electric shock or fire.
Doing so could lead to electric shock. When this signal is input ONthe fault cannot be reset with means other than turning the power OFF. For example, if the setting data is set to "5", the inverter will average five successive frequency command values, and will recognize the results as the final frequency command value. This parameter is used to stabilize the frequency command value recognized by the inverter.
Failure to do so could lead to electric shock. Page 83 Check Inspection Check item Check method Test criteria Instrument item frequency 1 Check output line 1 Measure voltage 1 Line output voltage balance between output balance is 4V between phases terminals.
Open collector output detection frequency setting] [Parameter P Confirm the tolerable range of the motor and machine before starting operation. Use this function according to the application. The details of the shipment inspection are saved when the unit is shipped.
Press the up button four times, and change the parameter No. Failure to do so could lead to electric shock or injury. The cause of the trip is saved in parameters P67 to P
Комментариев нет:
Отправить комментарий